Magnetic drill installation and maintenance

cate：Company News
inputtime：2022-06-27 10:16:04

Magnetic drill installation and maintenance

【description】The maintenance of magnetic drilling is a part that every customer must master If magnetic drilling does not pa

cate：Company News
inputtime：2022-06-27 10:16:04

content

The maintenance of magnetic drilling is a part that every customer must master. If magnetic drilling does not pay attention to maintenance, it will seriously affect the service life and drilling accuracy of magnetic drilling. First, the installation of magnetic drilling bit.

1, bit installation: installation of bit and belt from key converter drill prod-ucts head must ensure correct bit installed in place, with his left hand will quick change drill prod-ucts head to the screw counterclockwise to the end, the right hand will drill vertical alignment quick change drill prod-ucts hole up top of the head to the end, then the right hand gently rotate the drill bit to prove after hearing 1 of "cut" bit installed correctly in place; To remove the bit, twist the quick change clip head counterclockwise to the end with your left hand and pull the bit vertically down with your right hand.

2, feed tension adjustment: after the use of magnetic drill for a period of time, if it is found that the drill feed stroke is not controlled by the handle and directly slide, please open the iron cover, use the hex wrench to tighten the handle of the hex nut.

3. Overload: if the machine is overloaded for more than 10-16 seconds, the machine will automatically shut down. At this time, the motor switch can be turned off first, and the motor switch can be reopened to work normally again. Similarly, if the power is interrupted during the use of the machine, turn off the motor switch first after the call, and then turn on the motor switch to work normally again.

4. Feeding: Please slow down when drilling and feeding, and speed up the feeding speed after the drill bit is completely fed. Do not turn off the motor during the drilling process. If the drill bit is blocked in the hole, turn off the motor and slowly screw out the drill bit with a wrench.

5, the use of coolant: when drilling in the plane, please use cooling liquid cooling drill. Do not use any coolant when drilling on the top or side of the hole to avoid the inflow of coolant into the hollow drill and short circuit of the machine.

扫二维码用手机看

prev: 第一页

next: Magnetic drill definition

prev: 第一页

next: Magnetic drill definition